1. INTRODUCTION
SNC725 is a 16mins two-channel speech/melody and 4-channel wave-table melody voice chip. It based on reduced 16-bit fixed-point DSP architecture. SNC725 provides user some necessary and efficient DSP instructions. Furthermore, SNC725 provide one 10-bit PWM and one 10-bit DA converter to driving speaker for speech/melody output. User can select PWM or DA by programming DA/PWM control register, and only one function can be active at the same time.
2. FEATURES
♦ Power supply: 2.4V ~ 3.6V (for 2 battery application)
3.6V ~ 5.1V (for 3 battery application)
♦ Built-in a 16-bit DSP (Very Light Structure)
♦ Software-based voice/melody processing
♦ Rich Function Instruction Set
♦ System Clock
- 16MHz crystal or R-C type oscillator for system clock
- 0.25s real time clock is form 32768Hz crystal
♦ 8 MIPS CPU performance
♦ I/O Ports:
- 16 I/O pins (P0.0~P0.15) and 8 input pins (P1.0~P1.7)
- P0.15 with IR carrier signal
♦ RAM size: 2K*16 bits
♦ High performance program ROM: 32K*16 bits
♦ Data ROM size: 96K*16 bits
♦ Total ROM size: 128K*16 bits
♦ Maximum program size: 64K word
♦ 8 Interrupt Sources
- 4 for Internal Timer (timer0, 1, 2 and RTC)
- 4 for External (P0.0~P0.3)
♦ Two voice/melody channels
♦ Three 8-bit timer with auto-reload function
♦ Built in a 10-bit PWM Direct Drive circuit and a fixed current D/A output
♦ Sampling Rate: 6KHz ~16KHz
♦ Built-in software voice synthesizer (multiple bit-rate solution 2Kbps, 3.6Kbps, 5Kbps, 6Kbps, 8Kbps, 10Kbps, 12Kbps, 14Kbps, 16Kbps, 20Kbps, 24Kbps and 29Kbps @8K sampling rate)
♦ Built-in software melody synthesizer includes the dual-tone melody and 4-ch wave-table melody.
♦ Low Voltage Reset
|