ST92F120JR9T datasheet(243/320 Pages) STMICROELECTRONICS

243 / 320 page

243/320

J1850 Byte Level Protocol Decoder (JBLPD)

10.8 J1850 Byte Level Protocol Decoder (JBLPD)

10.8.1 Introduction

The JBLPD is used to exchange data between the

ST9 microcontroller and an external J1850 trans-

ceiver I.C.

The JBLPD transmits a string of variable pulse

width (VPW) symbols to the transceiver. It also re-

ceives VPW encoded symbols from the transceiv-

er, decodes them and places the data in a register.

In-frame responses of type 0, 1, 2 and 3 are sup-

ported and the appropriate normalization bit is

generated automatically. The JBLPD filters out

any incoming messages which it does not care to

receive. It also includes a programmable external

loop delay.

The JBLPD uses two signals to communicate with

the transceiver:

– VPWI (input)

– VPWO (output)

10.8.2 Main Features

SAE J1850 compatible

Digital filter

In-Frame Responses of type 0, 1, 2, 3 supported

with automatic normalization bit

Programmable External Loop Delay

Diagnostic 4x time mode

Diagnostic Local Loopback mode

Wide range of MCU

internal frequencies

allowed

Low

power

consumption

mode

(JBLPD

suspended)

Very low power consumption mode (JBLPD

disabled)

Don’t care message filter

Selectable VPWI input polarity

Selectable Normalization Bit symbol form

6 maskable interrupts

DMA transmission and reception with End Of

Block interrupts

ST92F120JR9T データシート(PDF) 243 Page - STMicroelectronics

ST92F120JR9T データシート(HTML) 243 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

データシートダウンロード