PC312XDP512F0CFVR datasheet(1089/1348 Pages) FREESCALE

1089 / 1348 page

Chapter 26 4 Kbyte EEPROM Module (S12XEETX4KV2)

MC9S12XDP512 Data Sheet, Rev. 2.21

Freescale Semiconductor

1091

26.4.2.1

Erase Verify Command

The erase verify operation will verify that the EEPROM memory is erased.

An example ﬂow to execute the erase verify operation is shown in Figure 26-18. The erase verify command

write sequence is as follows:

1. Write to an EEPROM address to start the command write sequence for the erase verify command.

The address and data written will be ignored.

2. Write the erase verify command, 0x05, to the ECMD register.

3. Clear the CBEIF ﬂag in the ESTAT register by writing a 1 to CBEIF to launch the erase verify

command.

After launching the erase verify command, the CCIF ﬂag in the ESTAT register will set after the operation

has completed unless a new command write sequence has been buffered. The number of bus cycles

required to execute the erase verify operation is equal to the number of words in the EEPROM memory

plus 14 bus cycles as measured from the time the CBEIF ﬂag is cleared until the CCIF ﬂag is set. Upon

completion of the erase verify operation, the BLANK ﬂag in the ESTAT register will be set if all addresses

in the EEPROM memory are veriﬁed to be erased. If any address in the EEPROM memory is not erased,

the erase verify operation will terminate and the BLANK ﬂag in the ESTAT register will remain clear.

PC312XDP512F0CFVR データシート(PDF) 1089 Page - Freescale Semiconductor, Inc