データシートサーチシステム
  Japanese  ▼
ALLDATASHEET.JP

X  

  • ADDR10

  • AI
    ## Overview of ADDR10 **ADDR10** is the signal for **address line bit 10** in a digital memory or address bus. It carries one bit (0 or 1) of an address from the controller to a memory chip such as SDRAM, DDR, or some flash and EEPROM devices. The "10" refers to bit position 10, which has value 2¹⁰ = 1024. --- ## Role in Memory Chips ### Basic Function - The controller places a row or column address on the address bus. - ADDR10 is one of those address lines. - It helps select a specific location in the memory array. ### Special Role in SDRAM and DDR In SDRAM and DDR devices, A10 has extra meaning depending on the command: | Command | Meaning of A10 | |---|---| | **ACTIVATE (RAS)** | A10 is part of the row address | | **READ / WRITE (CAS)** | **A10 = 1** enables auto-precharge (AP) after the access | | **READ / WRITE (CAS)** | **A10 = 0** keeps the bank open after the access | | **PRECHARGE** | **A10 = 1** precharges all banks; **A10 = 0** precharges only the selected bank | | **Mode Register Set** | A10 is used as part of the mode configuration value | --- ## Typical Electronic Parts Involved | Part | Function related to ADDR10 | |---|---| | **Memory controller / CPU** | Generates and drives the ADDR10 signal | | **SDRAM / DDR chip** | Receives ADDR10 and interprets it per command | | **Address bus traces** | PCB copper lines that carry ADDR10 | | **Termination resistors** | Reduce signal reflections on the line | | **Pull-up / pull-down resistors** | Keep the line at a defined level when idle | | **Decoupling capacitors** | Stabilize supply voltage near the memory chip | | **Buffer / level shifter** | Adapts voltage levels if needed | --- ## Common Troubleshooting Points - **Wrong timing or auto-precharge behavior:** Check that A10 is set correctly in READ/WRITE commands. - **Signal integrity problems:** Look at trace length matching, termination, and noise on the ADDR10 line. - **Short or open circuit:** Measure continuity between the controller pin and the memory pin. - **Stuck bit:** If ADDR10 stays at 0 or 1, the memory may misbehave or fail to address upper locations. --- ## Summary - ADDR10 is **address bit 10**, a single signal line in a memory address bus. - In SDRAM/DDR, it has **special command functions**, especially for auto-precharge and precharge-all. - Key related parts include the **controller, memory chip, PCB traces, termination, and decoupling components**. If you meant a specific chip or board (for example, a particular SDRAM model or microcontroller), tell me the part number and I can explain its ADDR10 pin in more detail.
    ✨ Follow-up Questions
    • ⤷What is the difference between A10 auto-precharge and manual precharge in SDRAM?
    • ⤷ How do I troubleshoot a stuck address line like ADDR10 on a PCB?
    • ⤷ What is the function of termination resistors on memory address buses?