Description
The STGAP2SiCS is an isolated single gate driver. The gate driver is characterized by 4 A current capability and rail-to-rail outputs, making the device also suitable for high power inverter applications such as motor drivers in industrial applications equipped with SiC MOSFET power switches. The configuration featuring single output pin and Miller CLAMP function allow avoiding gate spikes during fast commutations in half-bridge topologies. The device integrates protection functions: UVLO and thermal shut down are included to easily design highly reliable systems. Dual input pins allow choosing the control signal polarity and also implementing HW interlocking protection in order to avoid cross-conduction in case of controller malfunction. The device allows implementing negative gate driving, and the on board isolated DCDC converters allows working with optimized driving voltage for SiC MOSFET. The EVALSTGAP2SiCSC board allows evaluation of all the STGAP2SiCSC features while driving a half-bridge power stage with voltage rating up to 1200 V in TO-220 or TO-247 packages. The board components are easy to access and modify in order to make driver performance evaluation easier under different application conditions and fine adjustment of final application components. Product status link EVALSTGAP2SiCSC Demonstration board for STGAP2SiCSC isolated 4 A single gate driver EVALSTGAP2SiCSC Data brief DB4300 - Rev 1 - October 2020 For further information contact your local STMicroelectronics sales office.

Features
■ Board – High voltage rail up to 1200 V – Negative gate driving – Onboard isolated DC-DC converters to supply high-side and low-side gate drivers, fed by VAUX = 5 V, with 5.2 kV maximum isolation – 3.3 V VDD logic supply generated onboard or 5 V (externally applied) – Easy jumper selection of driving voltage configuration: +17/0 V; +17/-3 V; +19/0 V; +19/-3 V
■ Device – Driver current capability: 4 A source/sink @ 25 °C – 6000 V Galvanic isolation – Short propagation delay: 75 ns – UVLO function – Gate driving voltage up to 26 V – 3.3 V, 5 V TTL/CMOS inputs with hysteresis – Temperature shut down protection – Stand-by function – 4 A Miller CLAMP