Technical features
Mass 11.5 kg
Size 280 mm
Surface of rotor Coated in black
Material of electronics housing Die-cast aluminium
Material of impeller Aluminium sheet
Material of mounting plate Sheet steel, galvanised
Material of support bracket Steel, coated in black
Material of inlet nozzle Sheet steel, galvanised
Number of blades 7
Direction of rotation Clockwise, seen on rotor
Type of protection IP 54
Insulation class "B"
Humidity class F3-1
Max. permissible ambient motor
temp. (transp./ storage)
+80 °C
Min. permissible ambient motor
temp. (transp./storage)
-40 °C
Mounting position Shaft horizontal or rotor on bottom; rotor on top on request
Condensate discharge holes Rotor-side
Operation mode S1
Motor bearing Ball bearing
Technical features - Output 10 VDC, max. 10 mA
- Output 20 VDC, max. 50 mA
- Output for slave 0-10 V
- Input for sensor 0-10 V or 4-20 mA
- Alarm relay
- Motor current limit
- PFC, active
- RS485 MODBUS RTU
- Soft start
- Control input 0-10 VDC / PWM
- Control interface with SELV potential safely disconnected from the mains
- Over-temperature protected electronics / motor
- Line undervoltage / phase failure detection
EMC interference immunity Acc. to EN 61000-6-2 (industrial environment)
EMC harmonics Acc. to EN 61000-3-2/3
EMC interference emission Acc. to EN 55022 (Class B, household environment)
Touch current acc. IEC 60990
(measuring network Fig. 4, TN
system)
<= 3.5 mA
Electrical leads Via terminal box
Motor protection Thermal overload protector (TOP) wired internally
Protection class I (if protective earth is connected by customer)
Product conforming to standard EN 61800-5-1; CE
Approval CCC; EAC