Application Information
The TPMC310 is a conduction cooled single-width 32 bit PMC module providing two channel of high speed CAN bus interface.
The PLX PCI9030 PCI Target Chip is used for the PCI interface.
Two Philips SJA1000 CAN controllers (CAN specification 2.0B supported) are used for the two CAN bus channels.
The CAN bus I/O interface provides two independent channels, isolated from system logic and from each other. CAN High Speed transceivers are used for the CAN bus I/O interface. An on board termination option (solder pads) is provided for each CAN bus channel allowing to configure on board termination and pass through mode for the CAN bus.
The TPMC310 uses the P14 I/O connector for the CAN bus I/O interface.
Software support (TDRV010-SW-xx) for different operating systems is available.