Features
• AEC-Q100 qualified
• Two main 32-bit Power Architecture® VLE
compliant CPU core (e200z4), dual issue,
running in lockstep
– Single-precision floating point operations
– 16 KB local instruction SRAM and 64 KB
local data SRAM
– 4 KB I-Cache and 2 KB D-Cache
• One 32-bit Power Architecture® VLE compliant
I/O processor core (e200z2)
– Single-precision floating point operations
– Lightweight Signal Processing Auxiliary
Processing Unit (LSP APU) instruction
support for digital signal processing (DSP)
– 16 KB local instruction SRAM and 48 KB
local data SRAM
• 2624 KB on-chip flash memory
– Supporting EEPROM emulation (64 KB)
• 64 KB on-chip general-purpose SRAM
(+112 KB data RAM included in the CPUs)
• Multi-channel direct memory access controller
(eDMA) with 32 channels
• Dual interrupt controller (INTC)
• Dual phase-locked loops, including one
Frequency-modulated
• System integration unit lite (SIUL)
• Boot Assist Flash (BAF) supports factory
programming using a serial bootload through
the asynchronous CAN or LIN/UART
• Generic timer module (GTM122)
– Intelligent complex timer module
– 88 channels (24 input and 64 output)
– 3 programmable fine grain multi-threaded
cores
– 26 KB of dedicated SRAM
– Hardware support for engine control, motor
control and safety related applications
• Enhanced analog-to-digital converter system
with:
– 1 supervisor 12-bit SAR analog converter
– 4 separate fast 12-bit SAR analog
converters
– 2 separate 16-bit Sigma-Delta analog
converters
• 5 Deserial Serial Peripheral Interface (DSPI)
modules
• 5 LIN and UART communication interface
(LINFlexD) modules
• 3 MCAN interfaces with advanced shared
memory scheme, two supporting ISO CAN-FD
and one supporting TTCAN
• One Ethernet controller 10/100 Mbps,
compliant IEEE 802.3-2008
• Dual-channel FlexRay controller
• Nexus development interface (NDI) per IEEEISTO
5001-2003 standard, with partial support
for 2010 standard
• Device and board test support per Joint Test
Action Group (JTAG) (IEEE 1149.1)
• Single 5 V +/-10% Power supply supporting
cold start conditions (down to 3.0 V)
• Designed for eTQFP144 and eLQFP176