1 Features
1• −3-dB BW 45 MHz
• Supply Voltage Range 2.7 V to 12 V
• Slew Rate 40 V/μs
• Supply Current 600 μA
• Power Down Supply Current 15 μA
• Output Short Circuit Current 32 mA
• Linear Output Current ±20 mA
• Input Common Mode Voltage −0.3 V to 1.7 V
• Output Voltage Swing 20 mV from Rails
• Input Voltage Noise 40 nV/√Hz
• Input Current Noise 0.75 pA/√Hz

2 Applications
• High-Speed Clock Buffer/Driver
• Active Filters
• High-Speed Portable Devices
• Multiplexing Applications (LMV118)
• Current Sense Amplifier
• High-Speed Transducer Amplifier

3 Description
The LMV116 (single) rail-to-rail output voltage
feedback amplifiers offer high-speed (45 MHz), and
low-voltage operation (2.7 V) in addition to micropower
shutdown capability (LMV118).
Output voltage range extends to within 20 mV of
either supply rail, allowing wide dynamic range
especially in low voltage applications. Even with low
supply current of 600 μA, output current capability is
kept at a respectable ±20 mA for driving heavier
loads. Important device parameters such as BW, slew
rate, and output current are kept relatively
independent of the operating supply voltage by a
combination of process enhancements and design
architecture.
For portable applications, the LMV118 provides
shutdown capability while keeping the turnoff current
to 15 μA. Both turnon and turnoff characteristics are
well behaved with minimal output fluctuations during
transitions, thus the device can be used in powersaving
mode, as well as multiplexing applications.
Miniature packages (5-pin and 6-pin SOT-23) are
further means to ease the adoption of these lowpower,
high-speed devices in applications where
board area is at a premium.