1. General description
The NXU0104 is a 4-bit, dual-supply level translating
buffer with 3-state outputs. It features four data inputs
(An), four data outputs (YBn) and an output enable
input (OE).
Both VCCA and VCCB can be supplied at any voltage
between 0.9 V and 5.5 V making the device suitable
for translating between any of the voltage nodes (1.2 V,
1.5 V, 1.8 V, 2.5 V, 3.3 V and 5.0 V).
This device facilitates asynchronous communication
between data buses. Transmit data with a fixed
direction (unidirectionally) from the A bus to the B bus
on four channels. The OE pin can be referenced to
VCCA and VCCB domain and when OE pin is set LOW
the output is disabled and enter a high-impedance
OFF-state which isolates the buses. The OE pin can
be left floating or externally pulled down to ground to
ensure the high-impedance state of the output during
power up or power down.
This device ensures low static and dynamic power
consumption across the entire supply range and is
fully specified for partial power down applications using
IOFF. The IOFF circuitry prevents potentially damaging
backflow current through the device when it is powered
down or if one of the power supplies is disconnected
(floating).
No power supply sequencing is required and output
glitches during power supply transitions are prevented.
As a result, glitches will not appear on the output for
supply transitions during power-up/down.


2. Features and benefits
Wide supply voltage range:
• VCCA: 0.9 V to 5.5 V
• VCCB: 0.9 V to 5.5 V
Low power consumption for supply voltage range
1.1 V to 5.5 V
• 3 μA (Tamb = 25 °C)
• 5 μA (Tamb = -40 °C to +125 °C)
Schmitt-trigger inputs with integrated static high
ohmic pull-down resistor on the input
Maximum data rates:
• 250 Mbps (≥ 1.8 V to 5 V translation)
Output enable (OE) allows connection to VCCA
VCCB domain
Suspend mode when either one of the supply
voltages is below 100 mV or disconnected (floating)
Low noise overshoot and undershoot <10% of
VCCO
IOFF circuitry provides partial power-down mode
operation
Latch-up performance exceeds 100 mA per
JESD78D Class II
Complies with JEDEC standard:
• JESD8-12 (0.9 V to 1.3 V)
• JESD8-11 (1.4 V to 1.6 V)
• JESD8-7 (1.65 V to 1.95 V)
• JESD8-5 (2.3 V to 2.7 V)
• JESD8C (2.7 V to 3.6 V)
• JESD12-6 (4.5 V to 5.5 V)
ESD protection:
• HBM: ANSI/ESDA/JEDEC JS-001 class 2
exceeds 2500 V
• CDM: ANSI/ESDA/JEDEC JS-002 class C3
exceeds 1500 V
Specified from -40 °C to +85 °C and -40 °C to
+125 °C
Similar functions: NXU0204 and NXU0304
3. Applications
General purpose I/O level translation
Noisy environments or slow input signals
Supports push-pull voltage translation as UART,
SPI and JTAG protocols
Consumer