Description
Atmel’s SAM7S is a series of low pincount Flash microcontrollers based on the 32-bit ARM RISC processor. It features a high-speed Flash and an SRAM, a large set of peripherals, including a USB 2.0 device (except for the SAM7S32 and SAM7S16), and a complete set of system functions minimizing the number of external components. The device is an ideal migration path for 8-bit microcontroller users looking for additional performance and extended memory.

Features
• Incorporates the ARM7TDMI® ARM® Thumb® Processor
   – High-performance 32-bit RISC Architecture
   – High-density 16-bit Instruction Set
   – Leader in MIPS/Watt
   – EmbeddedICE™ In-circuit Emulation, Debug Communication Channel Support
• Internal High-speed Flash
   – 512 Kbytes (SAM7S512) Organized in Two Contiguous Banks of 1024 Pages of 256 Bytes (Dual Plane)
   – 256 Kbytes (SAM7S256) Organized in 1024 Pages of 256 Bytes (Single Plane)
   – 128 Kbytes (SAM7S128) Organized in 512 Pages of 256 Bytes (Single Plane)
   – 64 Kbytes (SAM7S64) Organized in 512 Pages of 128 Bytes (Single Plane)
   – 32 Kbytes (SAM7S321/32) Organized in 256 Pages of 128 Bytes (Single Plane)
   – 16 Kbytes (SAM7S161/16) Organized in 256 Pages of 64 Bytes (Single Plane)
   – Single Cycle Access at Up to 30 MHz in Worst Case Conditions
   – Prefetch Buffer Optimizing Thumb Instruction Execution at Maximum Speed
   – Page Programming Time: 6 ms, Including Page Auto-erase, Full Erase Time: 15 ms
   – 10,000 Write Cycles, 10-year Data Retention Capability, Sector Lock Capabilities, Flash Security Bit
   – Fast Flash Programming Interface for High Volume Production
• Internal High-speed SRAM, Single-cycle Access at Maximum Speed
   – 64 Kbytes (SAM7S512/256)
   – 32 Kbytes (SAM7S128)
   – 16 Kbytes (SAM7S64)
   – 8 Kbytes (SAM7S321/32)
   – 4 Kbytes (SAM7S161/16)
• Memory Controller (MC)
   – Embedded Flash Controller, Abort Status and Misalignment Detection
• Reset Controller (RSTC)
   – Based on Power-on Reset and Low-power Factory-calibrated Brown-out Detector
   – Provides External Reset Signal Shaping and Reset Source Status
• Clock Generator (CKGR)
   – Low-power RC Oscillator, 3 to 20 MHz On-chip Oscillator and one PLL
• Power Management Controller (PMC)
   – Software Power Optimization Capabilities, Including Slow Clock Mode (Down to 500 Hz) and Idle Mode
   – Three Programmable External Clock Signals
• Advanced Interrupt Controller (AIC)
   – Individually Maskable, Eight-level Priority, Vectored Interrupt Sources
   – Two (SAM7S512/256/128/64/321/161) or One (SAM7S32/16) External Interrupt Source(s) and One Fast Interrupt Source, Spurious Interrupt Protected
(Continue ...)