FEATURES
1. High capacity type power photoMOS  relay.
   Can switch a wide range of currents and  voltages. Can control various types of  loads, from very small loads to a maximum 6A AC/DC current for sequencers,  motors, and lamps.
2. Low ON resistance and high sensitivity.
   Low ON resistance of less than 50 mW on  a par with mechanical relays (AQZ262).
   High sensitivity LED operate current of 3  mA (at 25°C 77°F ).
3. AC/DC dual use
   Bi-directional control is possible. There is  no need to differentiate depending on the  load as was necessary with the conventional SSR.
4. 4-pin SIL type.
   4-pin SIL type of (L) 43.0 mm × (W) 9.0  mm × (H) 32.0 mm (L) 1.693 inch× (W)  .354 inch× (H) 1.260 inch.
5. Low-level off state leakage current
   In contrast to the SSR with an off state  leakage current of several milliamps, the  PhotoMOS relay features a very small off  state leakage current of only 10mA even  at the rated load voltage.
6. Controls low-level analog signals
   The triac, photocoupler, or SSR cannot be  used to control signals of less than several hundred mV. The high capacity type  power PhotoMOS relay feature extremely  low closed-circuit offset voltage to enable  control of low-level analog signals without  distortion.

TYPICAL APPLICATIONS
• Mercury relay replacement
• Railroad, traffic signals
• Compact motors, lamps, heaters
• OA equipment
• Measurement instruments