This document contains information on a new product. Specification and information herein are subject to change without notice.

Copyright

 2003 SOLOMON Systech Limited

Rev 1.2

01/2003

Read Status Byte ...............................................................................................................................................27

Data Read / Write ...............................................................................................................................................27

Address Increment Table (Automatic) ............................................................................................................27

Commands Required for R/

COMMAND DESCRIPTIONS ..................................................................................................................................28

Set Display On/Off .............................................................................................................................................28

Set Display Start Line .......................................................................................................................................28

Set Page Address ..............................................................................................................................................28

Set Lower Column Address .............................................................................................................................28

Set Segment Re-map ........................................................................................................................................28

Set Normal/Inverse Display ..............................................................................................................................28

Set Entire Display On/Off..................................................................................................................................28

Set LCD Bias ......................................................................................................................................................28

Software Reset...................................................................................................................................................28

Set COM Output Scan Direction ......................................................................................................................28

Set Power Control Register..............................................................................................................................29

Set Internal Regulator Resistors Ratio ...........................................................................................................29

Set Contrast Control Register..........................................................................................................................29

Set Display Offset..............................................................................................................................................29

Set Multiplex Ratio ............................................................................................................................................30

Set Power Save Mode .......................................................................................................................................30

Exit Power Save Mode ......................................................................................................................................30

Set N-line Inversion ...........................................................................................................................................30

Exit N-line Inversion ..........................................................................................................................................30

Set DC-DC Converter Factor ............................................................................................................................30

Set Icon Enable..................................................................................................................................................30

Start Internal Oscillator.....................................................................................................................................30