Rev B

PSLS01 SERIES

1 Watt

AC/DC Converter

Single Output

1/9/2018

Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 •

Fax 603-778-9797

website: www.wallindustries.com • e-mail: sales@wallindustries.com

Page 2 of 5

SPECIFICATIONS

All specifications are based on 25°C, Humidity <75%, Nominal Input Voltage, and Rated Output Current unless otherwise noted.

We reserve the right to change specifications based on technological advances.

SPECIFICATION

TEST CONDITIONS

Min

Typ

Max

Unit

GENERAL SPECIFICATIONS

Efficiency

230VAC, %Typ.

See Table

Switching Frequency

100

kHz

Isolation Voltage

Input to Output, Test Time: 1 min

3000

VAC

PHYSICAL SPECIFICATIONS

Weight

0.21oz (6g) Typ.

Dimensions (L x W x H)

Standard

1.38in x 0.66in x 0.43in

(35mm x 16.45mm x 11mm)

90º Bend Pin Package

1.38in x 0.71in x 0.43in

(35mm x 18mm x 0.11mm)

Cooling

Free Air Convection

SAFETY CHARACTERISTICS

Safety Standards & Certification

IEC60950, EN60950, UL60950

Safety Class

Class II

EMI

CE

CISPR32/EN55032

CIRSP32/EN55032

RE

CISPR32/EN55032

CISPR32/EN55032

ESD

IEC/EN61000-4-2

±4kV

Pref. Criteria B

RS

IEC/EN61000-4-3

Perf. Criteria A

EFT

IEC/EN61000-4-4

IEC/EN61000-4-4

Perf. Criteria B

Perf. Criteria B

Surge

IEC/EN61000-4-5

Perf. Criteria B

IEC/EN61000-4-5

Perf. Criteria B

CS

IEC/EN61000-4-6

Perf. Criteria A

Voltage Dips, Short Interruption, and

Voltage Variations Immunity

IEC/EN61000-4-11

Perf. Criteria B

NOTES

1. 90 degree SIP package is available for each model in this series. To indicate 90 degree package, add “-F” to model number. Ex. PSLS01-15B05SS-F.

2. Ripple and noise are measured by “parallel cable” method.

3. See Fig. 1 for recommended circuit.

4. See Fig. 2 for recommended circuit.

5. External electrolytic capacitors are required to modules, for more info refer to typical applications

6. In order to increase conversion efficiency of the product with light load in the design, product will have audio noise when it is operating, but will not affect

the product’s reliability and performance

7. Module required dispensing fixed after assembled.

8. This part is open frame, at least 6.4mm safety distance between primary and secondary external components of module is needed to meet safety

requirements.

9. Product customization is available.

*Due to advances in technology, specifications subject to change without notice.

CHARACTERISTIC CURVES

Temperature Derating Graph

Input Voltage Derating Graph

Note: This product is suitable for use in natural air cooling envirionments. If in a closed environment, please contact factory.