FT27C010 datasheet(3/11 Pages) FORCE

3 / 11 page

FT27C010(L)

Note:

1. Minimum voltage is -0.6V dc which may undershoot to -2.0V for pulses of less than 20 ns. Maximum output pin voltage is

VCC + 0.75V dc which may overshoot to +7.0 volts for pulses of less than 20 ns.

Notes: 1. X can be VIL or VIH.

2. Refer to Programming Characteristics

3. VH = 12.0 ± 0.5V.

4. Two identifier bytes may be selected. All Ai inputs are held low (VIL), except A9 which is set to VH and A0 which is toggled low

(VIL) to select the Manufacturer’s Identification byte and high (VIH) to select the Device Code byte.

Absolute Maximum Ratings*

Temperature Under Bias................................ -55°C to +125°C

*NOTICE:

Stresses beyond those listed under “Absolute Maxi-

mum Ratings” may cause permanent damage to

the device. This is a stress rating only and func-

tional operation of the device at these or any other

conditions beyond those indicated in the opera-

tional sections of this specification is not implied.

Exposure to absolute maximum rating conditions

for extended periods may affect device reliability.

Storage Temperature ..................................... -65°C to +150°C

Voltage on Any Pin with

Respect to Ground .........................................-2.0V to +7.0V(1)

Voltage on A9 with

Respect to Ground ......................................-2.0V to +14.0V(1)

VPP Supply Voltage with

Respect to Ground .......................................-2.0V to +14.0V(1)

Operating Modes

Mode\Pin

PGM

Outputs

Read

VIL

X(1)

DOUT

Output Disable

VIH

XXX

High

Standby

VIH

XXX

High

Rapid Program(2)

VIL

VIH

VIL

VPP

DIN

PGM Verify

VIL

VIH

VPP

DOUT

PGM Inhibit

VIH

VPP

High Z

Product Identification(4)

VIL

A9 = VH(3)

A0 = VIH or VIL

A1 - A16 = VIL

Identification Code

2006

3/11

Rev 1

FT27C010 データシート(PDF) 3 Page - Force Technologies Ltd

FT27C010 データシート(HTML) 3 Page - Force Technologies Ltd

Html Pages

1 2 3 4 5 6 7 8 9 10 11

データシートダウンロード