Engineering Bulletin

EB311

6

MOTOROLA

3. Operation — Standard monitor mode entry:

a.

Launch P&E’s WINIDE in the ICS08SRZ software.

b.

Open desired file. (Demo file can be used for testing

purposes.)

c.

Assemble/Compile the file (see Figure 7).

d.

Apply power to the external communications circuit.

e.

Turn on power to the target.

f.

Launch the programmer.

g.

From “Target Hardware Type,” select “Class III” (see

Figure 8).

h.

From “PC Serial Port Configuration,” select the PC port in use

and the appropriate baud rate (Table 2).

i.

From “Target MCU Security Bytes,” select appropriate

security code (blank part = FF).

j.

Select “Contact Target with these Settings…”

k.

Follow the instructions in the “Power Cycle Dialog” window.

l.

Select appropriate algorithm for the part. The high-speed

algorithm will not work at 14.4 and 28.8 kbaud.

m. Double click on “Erase Module” – EM (see Figure 9).

n.

Double click on “Program Module” – PM.

o.

Record security bytes. This information can be seen by

quitting and then re-entering the programmer. The S19 record

will have the same security bytes as the part just programmed

as long as it is not changed. The security bytes consist of the

information stored in the interrupt vectors, $FFF6–$FFFD.

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com