CS7666 datasheet(35/42 Pages) CIRRUS

35 / 42 page

CS7666

DS302PP1

Input Data and Clocks

DI[9:0] - Digital Mosaic Inputs.

CMOS level mosaic coded CCD input data from CCD digitizer

CLKIN - Mosaic Input Data Clock, PIN 55.

Main system input clock, used to strobe incoming digital CCD mosaic data. The CLKIN

frequency is the mosaic input data rate.

CLKIN2X - Mosaic Input Data Interpolation Clock, PIN 56.

Mosaic input data interpolation clock or crystal oscillator input. Twice the CLKIN input in

CS7665 compatibility mode (non-interpolated output data ... see INTERP description). Twice

the 5/4 output rate clock when internal 5 to 4 horizontal data rate scaler is in operation

(CS7665 compatibility mode.) In CS7666 native mode, this pin operates as the crystal oscillator

input pin. The required crystal frequency is 2 X (SCALER RATIO) X (INPUT DATA RATE).

For example a 512x492 pixel imager running at 9.818 MHz and scaled by a factor of

5:4

would require 2 X (5/4) X (9.818) = 24.54 MHz.

CLK_GRG - CCD Sample Clock, PIN 51.

This clock is scaled by the internal PLL and is equal to the CLKIN2X frequency divided by the

scaling ratio. This clock is intended to connect to the CS7615 master clock pin (pin 32).

XTAL_OUT – Crystal oscillator output, PIN 52.

When using the internal crystal oscillator, connect the external crystal to the XTAL_OUT and

CLKIN2X pins.

HREFIN - Horizontal Input Timing Reference, PIN 32.

Active low horizontal input timing reference. Used to synchronize the output timing signals

with the incoming mosaic data and timing. When used with CCD digitizers like the CS7615

which imbed the necessary timing signals in the data stream, the HREFIN signal is not needed.

VREFIN - Vertical Input Timing Reference, PIN 33.

Active low vertical input timing reference. Used to synchronize the output timing signals with

the incoming mosaic data and timing. When used with CCD digitizers like the CS7615 which

embed the necessary timing signals in the data stream, the VREFIN signal is not needed.

2C Serial Control

SDA - Primary I

2C Data Bus, PIN 28.

Primary I2C data bus. Used with SCL to read and write the internal register set.

SCL - Primary I2C Clock, PIN 29.

Primary I

2C Clock. Used with SDA to read and write the internal register set.

CS7666 データシート(PDF) 35 Page - Cirrus Logic

CS7666 データシート(HTML) 35 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42

データシートダウンロード