IIS2DLPCTR datasheet(26/69 Pages) STMICROELECTRONICS

部品番号	IIS2DLPCTR

部品情報	MEMS digital output motion sensor: high-performance ultra-low-power 3-axis accelerometer for industrial applications

PDF	69 Pages

Scroll/Zoom	100%

メーカー	STMICROELECTRONICS [STMicroelectronics]

ホームページ	http://www.st.com

Logo

26 / 69 page

Terminology and functionality

IIS2DLPC

26/69

DocID031788 Rev 4

3.5

Factory calibration

The IC interface is factory-calibrated for sensitivity (So) and Zero-g level offset.

The trim values are stored inside the device in nonvolatile memory. Any time the device is

turned on, the trimming parameters are downloaded into the registers to be used during

active operation. This allows using the device without further calibration. If an accidental

write occurs in the registers where trimming parameters are stored, the BOOT bit in CTRL2

(21h) can help to retrieve the correct trimming parameters from nonvolatile memory without

the need to switch on/off the device. This bit is automatically reset at the end of the

download operation. Setting this bit has no impact on the control registers.

3.6

Temperature sensor

The temperature is available in OUT_T_L (0Dh), OUT_T_H (0Eh) stored as two's

complement data, left-justified in 12-bit mode and in OUT_T (26h) stored as two's

complement data, left-justified in 8-bit mode.

Refer to Table 6: Temperature sensor characteristics for the conversion factor.

IIS2DLPCTR データシート(PDF) 26 Page - STMicroelectronics