TLE5041PLUSC datasheet(18/30 Pages) INFINEON

18 / 30 page

TLE5041plusC

Specification

Figure 12

Period jitter definition is valid for measurement on rising-to-rising or falling-to-falling edge

3.4.2

Magnetic Input Characteristics

All magnetic input values specified at constant sinusoidal amplitude and constant offset over operating range,

unless otherwise specified. Magnetic values are referred to the location at the silicon surface. Typical values are

related to VDD = 12V and TA = 25°C.

Table 5

Magnetic input values

Parameter

Notes

Threshold limit

1) 2) 3)

1 Hz < f

MAG < 5000 Hz,

BY < 0.15 mT, Bext_XYZ =

0mT

Start-up threshold peak to peak value3)

1 Hz < f

MAG < 5000 Hz,

Y < 0.15 mT, Bext_XYZ = 0

Internal offset drift

1) Refer to Figure 6 “Offset calibration of TLE5041plusC” on Page 11. dB

Limit_X is a 99% criteria, calculated out of

measured sensitivity.

2)Threshold limit dBLimit_X is increased by 25% under influence of an in-plane magnetic induction perpendicular to

the sensitive direction (refer to Chapter 3.3 “Operating Range” on Page 15 of B

ext_XYZ).

Note: In typical encoder wheel applications, at large air gaps where dB

X is as low as dBLimit_X, the in-plane

magnetic induction perpendicular to the sensitive direction BY is smaller than 0.15mT.

3) Not subject to production test, verified by design/characterisation

4) dB

Startup_X is the minimum DNC at start-up.

Data Sheet

V 1.2, 2018-01-18

Symbol

Values

Unit

min.

typ.

max.

Limit_X

0.1

0.18

0.3

Startup_X

0.2

0.36

0.6

dBX_Drift

0.1

TLE5041PLUSC データシート(PDF) 18 Page - Infineon Technologies AG

TLE5041PLUSC データシート(HTML) 18 Page - Infineon Technologies AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30

データシートダウンロード