8-Ch Tx Active Beamforming IC

27.5 – 31.0 GHz

F6522

Short-Form Datasheet

© 2020 Renesas Electronics Corporation

1

March 13, 2020

Description

The F6522 is an 8-channel transmit active beamforming RFIC

designed for application in Ka-Band SATCOM planar phased array

antennas. The IC has a single common RF input port and eight

output channels. The eight independently controlled output

channels can drive eight single-polarized elements or four dual-

polarized elements of an electronically scanned array (ESA). Each

channel has 6 bits of digital phase control covering 360° and 25dB

of gain control with a minimum step size of 0.2dB, enabling precise

beam pattern and polarization control.

Operating from a single supply of 2.1 - 2.5V, the RFIC has 28dB of

nominal small signal gain with a typical P1dB of 11dBm per

channel. The F6522 is highly efficient and features a low power

standby mode as well as independent enable controls on every

channel. The device’s SPI bus and control pins operate from

standard 1.8V logic at speeds up to 50MHz. Advanced digital

modes and large on-chip memory allows for < 100ns beam position

switching times at the array level, greatly reducing dead time and

latency.

Finally, the compact and CTE-matched FC-BGA organic package

with all single-ended 50ohm matched RF ports greatly simplifies

the physical integration of the F6522 onto large antenna panels.

Typical Applications



Phased array antennas



Ka-band SATCOM terminals



Aerospace and maritime

Features



27.5 – 31.0GHz operation



Supports 4 dual-pol elements or 8 single-pol



360° phase control with 6-bit resolution



25dB gain control with 0.2dB minimum step



28dB small signal gain



11dBm output P1dB



2.3V nominal single supply input



Standard 1.8V digital logic



Temperature compensation



Temperature sensor with digital readout



Advanced digital modes with fast beam steering



On-chip beam-state memory



3.8 × 4.6 × 0.9 mm, 62-pin FC-BGA package

Block Diagram