MODEL: RPPD

RPPD SPECIFICATIONS

ES-1693 Rev.20 Page 4/9

http://www.m-system.co.jp/

OUTPUT PULSE WIDTH

■ Equal to the input: Output waveforms have the same

period and duty ratio as those of input waveforms (when DC

coupled).

■ One-shot Output

This unit detects a pulse sink and outputs [input pulse width

±20 %]; 50 msec. standard

Note: 2 types of one-shot detection are available: pulse rise

or sink. Refer to the table on the "Output Logic" section and

specify when ordering.

Optional pulse width: 30 μsec. – 300 msec.

INSTALLATION

Power consumption

•AC: Approx. 5.5 VA

•DC: Approx. 3.3 W (140 mA at 24 V)

Operating temperature: -5 to +60°C (23 to 140°F)

Operating humidity: 30 to 90 %RH (non-condensing)

Mounting: Surface or DIN rail

Weight: 200 g (0.44 lb)

PERFORMANCE

Response time

1 - 4 μsec. delay occurs when the pulse rises and falls.

• Open collector: The delay could be much longer for certain

types of load.

• High power photo MOSFET relay: The output is delayed by

10 msec. at the rise, by 3 msec. at the fall.

Insulation resistance: ≥ 100 MΩ with 500 V DC

Dielectric strength: 2000 V AC @1 minute (input to output

to power to ground)

STANDARDS & APPROVALS

EU conformity:

EMC Directive

EMI EN 61000-6-4

EMS EN 61000-6-2

RoHS Directive

EN 50581