MCP3461RT-ESLASHST datasheet(80/118 Pages) MICROCHIP

80 / 118 page

MCP3461/2/4R

DS20006404C-page 80

 2020-2021 Microchip Technology Inc.

6.8

Interrupts Description

The MCP3461/2/4R devices incorporate multiple

interrupt mechanisms to be able to synchronize the

device with an MCU and to warn against external per-

turbations. There are four events that can generate

interrupt flags:

• Conversion Start

• Data Ready

•POR

• CRC Error on the Register Map Configuration

Additionally, there are three independent interrupt

mechanisms that allow the devices to be implemented

in many different applications and configurations. A

summary of the different mechanisms is available in

Table 6-3.

TABLE 6-3:

INTERRUPT DESCRIPTION SUMMARY TABLE

Interrupt Flag Type

Description

Clearing Procedure

STATUS Byte

Three Status bits (DR_STATUS,

CRCCFG_STATUS, POR_STATUS) are

latched together after device address

detection and clocked out during each

command on the SDO STATUS byte.

Cleared when STATUS byte clocking is finished

(on the last SCK falling edge).

IRQ Register Status

Bits

IRQ register Status bits can be read when

reading the address 0x5 (IRQ register).

The IRQ latching occurs at the beginning

of the IRQ register reading.

Cleared when the IRQ register reading is

finished (on the last SCK falling edge).

IRQ Pin State

• When IRQ_MODE[1] = 0, the IRQ pin

can be asserted to logic low by any of

the interrupts.

• When IRQ_MODE[1] = 1, only POR

and CRC interrupts can assert the

IRQ pin to logic low.

• Conversion start interrupt is automatically

cleared at the beginning of a new

conversion cycle after a TSTP timing.

• DR interrupt is cleared by the first SCK

falling edge of an ADC read, or

automatically 16 DMCLKs before a new

data ready in Continuous Conversion mode

or in Scan mode.

• POR interrupt is cleared on the first CS

falling edge when both AVDD and DVDD

monitoring circuits detect that their power

supply is over their respective thresholds.

• CRCCFG interrupt is cleared when the

device is unlocked (writing 0xA5 to LOCK

start/restart conversion is performed.

MCP3461RT-E/ST データシート(PDF) 80 Page - Microchip Technology

MCP3461RT-E/ST データシート(HTML) 80 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

データシートダウンロード