User Manual

4 of 41

Revision 1.6

2019-07-16

EVAL-M3-102T User Manual

iMOTION™ Modular Application Design Kit

Introduction

2

Introduction

The EVAL-M3-102T evaluation board is a part of the iMOTION™ Modular Application Design Kit for drives

(iMOTION™ MADK). In order to run a motor, the mating power board is required to interface this evaluation

board.

The MADK platform is intended to use various power stages with different control boards. These boards can

easily be interfaced through the 30-pin iMOTION™ MADK M3, or the 30-pin iMOTION™ MADK M3 interface

connector. This board is equipped with 30-pin M3 connector and is intended for power factor correction and

single motor control only.

This evaluation board is designed to give comprehensible solutions of sensorless control of permanent magnet

motors over the full speed range. It provides a capable of 3-phase and type 3 of 2-phase modulation, a micro-

USB connector and on board debugger isolated by digital isolator, and UART interface.

The EVAL-M3-102T evaluation board is available from Infineon. The features of this board are described in the

main feature chapter of this document, whereas the remaining paragraphs provide information to enable the

customers to copy, modify and qualify the design for production according to their own specific requirements.

Environmental conditions were considered in the design of the EVAL-M3-102T, but it is not qualified regarding

safety requirements or manufacturing and operation over the whole operating temperature range or lifetime.

The boards provided by Infineon are subject to functional testing only.

Evaluation boards are not subject to the same procedures as regular products regarding Returned Material

Analysis (RMA), Process Change Notification (PCN) and Product Discontinuation (PD). Evaluation boards are

intended to be used under laboratory conditions by technical specialists only.

Figure 1 shows the evaluation board EVAL-M3-102T. This document explains the features and details of this board

as well as control IC which is IMC102T-F064.

Figure 1

Evaluation board EVAL-M3-102T