A22Z-R datasheet(29/52 Pages) OMRON

29 / 52 page

A22NE-P

• Do not insert more than one wire into each terminal insertion hole.

• Do not mount A22N-P or A22NE-P Push-In Plus terminal switch

blocks on A22N screw terminal blocks. Doing so may result in

unsatisfactory performance.

• When mounting on a device with high airtightness, test operation

in advance. There is a risk that the negative pressure will prevent

the Operation Unit of from returning.

• In the case of loads where an inrush current occurs when the

contact is opened or closed, the durability may reduce due to

extreme wear on the contacts.

If necessary, insert a contact protection circuit.

Wiring

1. Connecting Wires to the Push-In Plus Terminal Block

Part Names of the Terminal Block

Connecting Wires with Ferrules and Solid Wires

• Insert the solid wire or ferrule straight into the terminal block until

the end strikes the terminal block. The angle should be

approximately 6

°.

• If a wire is difficult to connect because it is too thin, use a flat-blade

screwdriver in the same way as when connecting stranded wires.

Precautions for Correct Use

Release hole

Terminal (insertion) hole

Ferrule or solid wire

Approx. 6˚

The wiring for the Lighting Unit and Switch Block (2 contacts) are the

same as for the Switch Block (1 contact) shown in the above illustra-

tion.

A22Z-R データシート(PDF) 29 Page - Omron Electronics LLC