FDA903D-EHT datasheet(61/82 Pages) STMICROELECTRONICS

部品番号	FDA903D-EHT

部品情報	1 x 45 W class D digital input automotive power amplifier with ILoad current monitoring, wide voltage operation range for car audio and telematic

PDF	82 Pages

Scroll/Zoom	100%

メーカー	STMICROELECTRONICS [STMicroelectronics]

ホームページ	http://www.st.com

Logo

61 / 82 page

DocID031502 Rev 2

61/82

FDA903D

I2C bus interface

Figure 72. Without/with auto-increment reading procedure

If a microcontroller tries to read an undefined register, FDA903D will return a "0xFF" data;

for more details refer directly to I2C specification.

14.3

Data validity

The data on the SDA line must be stable during the high period of the clock. The HIGH and

LOW state of the data line can only change when the clock signal on the SCL line is LOW.

14.4

Start and stop conditions

A start condition is a HIGH to LOW transition of the SDA line while SCL is HIGH.

The stop condition is a LOW to HIGH transition of the SDA line while SCL is HIGH.

14.5

Byte format

Every byte transferred to the SDA line must contain 8 bits. Each byte must be followed by an

acknowledge bit. The MSB is transferred first.

14.6

Acknowledge

The transmitter* puts a resistive HIGH level on the SDA line during the acknowledge clock

pulse. The receiver** has to pull-down (LOW) the SDA line during the acknowledge clock

pulse, so that the SDA line is stable LOW during this clock pulse.

* Transmitter

= master (μP) when it writes an address to the FDA903D

= slave (FDA903D) when the μP reads a data byte from FDA903D

** Receiver

= slave (FDA903D) when the μP writes an address to the FDA903D

= master (μP) when it reads a data byte from FDA903D

FDA903D-EHT データシート(PDF) 61 Page - STMicroelectronics