CASES

0.000

0.097

(2.46)

0.697

(17.70

Squared corner and dot on

top of case indicate pin one.

0.397

(10.08)

Projection Weld

Seam Seal

FMSA EMI Filter and STF EMI Filter

1

3

8

4

7

2

65

BOTTOM VIEW CASE A1

0.018 ± 0.002 dia.

(0.46 ± 0.05)

Seal hole: 0.056 ±0.002 (1.42 ±0.05)

Case A1, Rev B, September 8, 2005

Please refer to the numerical dimensions for accuracy. All information is believed to be accurate,

but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make

changes in products or specifications without notice.

Copyright © 1999-2005 Interpoint Corp. All rights reserved.

Case dimensions in inches (mm)

Tolerance ±0.005 (0.13) for three decimal places

±0.01 (0.3) for two decimal places

unless otherwise specified

CAUTION

Heat from reflow or wave soldering may damage the device.

Solder pins individually with heat application not exceeding 300°C for 10 seconds per pin