LS-T3 datasheet(45/64 Pages) IDEC

45 / 64 page

Instructions

Panel Mounting

• Remove the contact block from the operator. Remove the locking

ring from the operator. Insert the operator into the panel cut-out

from the front, tighten the locking ring from the back, then install

the contact block to the operator.

Pull up the locking lever.

Turn the lever to the left.

Pull out the contact block.

Removing and Installing the Contact Block

1. To remove the operator from the contact block, pull up the locking

lever and turn it to the left. Then the operator can be pulled out.

2. To reinstall, place the TOP marking on the operator and the idec

marking on the contact block mounting adapter in the same

direction, and insert the operator into the contact block mounting

adapter. Then turn the locking lever to the right.

Notes for Panel Mounting

Use the optional locking ring wrench (MW9Z-T1) to mount the op-

erator onto a panel. Tightening torque must not exceed 2.0 N·m. Do

not use pliers. Excessive tightening will damage the locking ring.

Removing Contact Blocks and Full

Voltage Adapter

Insert a flat screwdriver between the latch and contact block mount-

ing adapter, and disengage the latch.

Make sure to remove the lamp and contact blocks before removing

the full voltage adapter.

Lamp

ÇÇ

Full Voltage Adapter

Contact Block

YW Series Emergency Stop Switches ø22

LS-T3 データシート(PDF) 45 Page - IDEC Corporation