| データシートサーチシステム |
|
AT25SL321 データシート(PDF) 21 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
AT25SL321 データシート(HTML) 21 Page - Renesas Technology Corp |
|
21 / 82 page ![]() DS-AT25SL321-112 Rev. J Page 21 Nov 1, 2022 © 2022 Renesas Electronics AT25SL321 Datasheet 8.2 Write Enable (06h) Write Enable command is for setting the Write Enable Latch (WEL) bit in the Status Register. The WEL bit must be set prior to every Program, Erase and Write Status Register command. To enter the Write Enable command, drive CS low prior to driving the command 06h onto the SI pin on the rising edge of SCK, and then driving CS high to terminate the operation. Figure 4. Write Enable Command for SPI Mode (left) and QPI Mode (right) 03 5 246 7 1 Mode 3 Mode 0 Mode 3 Mode 0 High-Impedance SO SI IO IO IO IO SCK SCK CS Command 0 1 Mode 3 Mode 0 Mode 3 Mode 0 CS (06h) Command |
|
リンク URL |
| ALLDATASHEETはお客様のビジネスに役立ちますか? [ DONATE ] |
Alldatasheetは | 広告 | お問い合わせ | プライバシーポリシー | データシートへのリンク | リンク交換 | メーカーリスト All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |