AT89LP216-20PI datasheet(84/90 Pages) ATMEL

84 / 90 page

3621A–MICRO–6/06

AT89LP216 [Preliminary]

26.2

16S2 – SOIC

2325 Orchard Parkway

San Jose, CA 95131

TITLE

DRAWING NO.

REV.

16S2, 16-lead, 0.300" Wide Body, Plastic Gull

Wing Small Outline Package (SOIC)

1/9/02

16S2

Side View

Top View

End View

COMMON DIMENSIONS

(Unit of Measure = inches)

SYMBOL

MIN

NOM

MAX

NOTE

Notes: 1. This drawing is for general information only; refer to JEDEC Drawing MS-013, Variation AA for additional information.

2. Dimension "D" does not include mold Flash, protrusions or gate burrs. Mold Flash, protrusions and gate burrs shall not exceed

0.15 mm (0.006") per side.

3. Dimension "E" does not include inter-lead Flash or protrusion. Inter-lead Flash and protrusions shall not exceed 0.25 mm

(0.010") per side.

4. "L" is the length of the terminal for soldering to a substrate.

5. The lead width "B", as measured 0.36 mm (0.014") or greater above the seating plane, shall not exceed a maximum value of 0.61 mm

(0.024") per side.

0.0926

0.1043

0.0040

0.0118

0.0130

0.0200

0.0091

0.0125

0.3977

0.4133

0.2914

0.2992

0.3940

0.4190

0.0160

0.050

0.050 BSC

AT89LP216-20PI データシート(PDF) 84 Page - ATMEL Corporation

AT89LP216-20PI データシート(HTML) 84 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90

データシートダウンロード