SMD Removal

(With solder iron or warm air bath)



Apply flux to all leads.



Melt CHIP QUIK® uniformly on all pins.



Maintain alloy in molten state long enough to release chip.



Lift chip from board with dental pick or vacuum pen.

CLEAN UP



While molten, use cotton swab and flux to move excess to an unused section of board.



While applying heat, polish each pad with a swab and flux until thoroughly clean.



At room temperature, clean residue with alcohol pad.



You are now ready to install the new chip.

2.5 ft of Chip Quik® material, removes 1250 to 1500 SMD pins.

Conforms to the following Industry Standards:

J-STD-006C, Amendments 1 & 2 (Solder Alloys and Fluxed/Non-Fluxed Solders):

Yes

RoHS 2 Directive 2011/65/EU:

No

2

© 1994-2015 Chip Quik® Inc.