2-657
RF5189
Rev A7 060127
Pin
Function
Description
Interface Schematic
1RF IN
RF input. Input is matched to 50
Ω and DC block is provided internally.
2NC
No connect. Recommend connecting to ground.
3BIAS1GND
Ground for first stage bias circuit. For best performance, keep traces
physically short and connect immediately to ground plane.
See pin 4.
4VREG1
First stage input bias. This pin requires a regulated supply to maintain
nominal bias current.
5VREG2
Second stage input bias. This pin requires a regulated supply to main-
tain nominal bias current. Usually connected to VREG1.
See pin 4.
6BIAS2GND
Ground for second stage bias circuit. For best performance, connect to
ground with a choke inductor.
See pin 4.
7
PWR SEN
Provides an output voltage proportional to output RF level.
8RF OUT
RF output. Output is matched to 50
Ω and DC block is provided inter-
nally.
9RF OUT
Same as pin 8.
See pin 8.
10
VCC2
Second stage output bias. Supply should be connected through a
choke inductor sized appropriately to handle the output bias current.
See pin 8.
11
VCC2
Same as pin 10.
See pin 8.
12
VCC1
First stage output bias. This pin is sensitive to bypass capacitors placed
close to it. Place an RF short approximately 200mils from this pin
before any other supply connections.
See pin 1.
Pkg
Base
GND
Ground connection. The backside of the package should be connected
to the ground plane through a short path (i.e., vias under the device will
be required).
INPUT
MATCH
VCC1
INTERSTAGE
MATCH
BIAS
VREG1
VREG2
BIAS
GND1
BIAS
GND2
RF OUT
OUTPUT
MATCH
VCC2
Japanese ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
