Preliminary Technical Data

ADL5532

Rev. PrD 5/07 | Page 7 of 8

EVALUATION BOARD

Figure 6 shows the schematic for the ADL5532 evaluation

board. The board is powered by a single 5V supply.

The components used on the board are listed in. Table 4 Power

can be applied to the board through clip-on leads (Vcc, Gnd), or

through Jumper W1.

Figure 6. Evaluation Board Schematic

Figure 7. Evaluation Board Layout (Top)

Figure 8. Evaluation Board Layout (Bottom)

Table 4. Evaluation Board Configuration Options

Component

Function

Default Value

C1, C2

AC-coupling capacitors.

10 nF 0402

C3,

Provides decoupling for the on board linearizer.

C3 100 nF 0603

C4

Stabilizes the internal feedback loop for operation below 50 MHz.

C4 100 nF 0603

C5, C6

Power Supply decoupling capacitors capacitor.

C5 10 nF 0603

C6 1 μF 0603

C7, C8

Open 0603

L1

DC bias inductor.

82 nH L0603

L2, L3, L4, L5

Open 0603

VCC & GND

Clip-on terminals for power supply.

VCC Red

GND Black

W1

2-pin jumper for connection of ground and supply via cable.

R1, R2

Open 0603