Data Sheet

MAT01

Rev. D | Page 5 of 12

ABSOLUTE MAXIMUM RATINGS

Table 3.

Parameter1

Rating

Breakdown Voltage of

Collector to Base Voltage (BVCBO)

45 V

Collector to Emitter Voltage (BVCEO)

45 V

Collector to Collector Voltage (BVCC)

45 V

Emitter to Emitter Voltage (BVEE)

45 V

Emitter to Base Voltage (BVEBO)2

5 V

Current

Collector (IC)

25 mA

Emitter (IE)

25 mA

Total Power Dissipation

Case Temperature ≤ 40°C3

1.8 W

Ambient Temperature ≤ 70°C4

500 mW

Temperature Range

Operating

−55°C to +125°C

Junction

−55°C to +150°C

Storage

−65°C to +150°C

Lead Temperature (Soldering, 60 sec)

300°C

1 Absolute maximum ratings apply to packaged devices.

2 Application of reverse bias voltages in excess of rating shown can result in

degradation of hFE and hFE matching characteristics. Do not attempt to

measure BVEBO greater than the 5 V rating.

3 Rating applies to applications using heat sinking to control case

temperature. Derate linearity at 16.4 mW/°C for case temperatures above

40°C.

4 Rating applies to applications not using heat sinking; device in free air only.

Derate linearity at 6.3 mW/°C for ambient temperatures above 70°C.

Stresses above those listed under Absolute Maximum Ratings

may cause permanent damage to the device. This is a stress

rating only; functional operation of the device at these or any

other conditions above those indicated in the operational

section of this specification is not implied. Exposure to absolute

maximum rating conditions for extended periods may affect

device reliability.

ESD CAUTION