TC1072_07 datasheet(11/22 Pages) MICROCHIP

11 / 22 page

DS21354D-page 11

TC1072/TC1073

3.0

PIN DESCRIPTIONS

The descriptions of the pins are listed in Table 3-1.

TABLE 3-1:

PIN FUNCTION TABLE

3.1

Input Voltage Supply (VIN)

Connect unregulated input supply to the VIN pin. If

there is a large distance between the input supply and

the LDO regulator, some input capacitance is

necessary for proper operation. A 1 µF capacitor

connected from VIN to ground is recommended for

most applications.

3.2

Ground (GND)

Connect the unregulated input supply ground return to

GND. Also connect the negative side of the 1 µF typical

input decoupling capacitor close to GND and the

negative side of the output capacitor COUT to GND.

3.3

Shutdown Control Input (SHDN)

The regulator is fully enabled when a logic-high is

applied to SHDN. The regulator enters shutdown when

a logic-low is applied to SHDN. During shutdown,

output voltage falls to zero, ERROR is open-circuited

and supply current is reduced to 0.5 µA (maximum).

3.4

Out-Of-Regulation Flag (ERROR)

ERROR goes low when VOUT is out-of-tolerance by

approximately – 5%.

3.5

Reference Bypass Input (Bypass)

Connecting a 470 pF to this input further reduces

output noise.

3.6

Regulated Voltage Output (VOUT)

Connect the output load to VOUT of the LDO. Also

connect the positive side of the LDO output capacitor

as close as possible to the VOUT pin.

Pin No.

(6-Pin SOT-23)

Symbol

Description

1VIN

Unregulated supply input.

GND

Ground terminal.

SHDN

Shutdown control input.

4ERROR

Out-of-Regulation Flag. (Open drain output).

Bypass

Reference bypass input.

6VOUT

Regulated voltage output.

TC1072 データシート(PDF) 11 Page - Microchip Technology

TC1072 データシート(HTML) 11 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22

データシートダウンロード