TSA1204

Application information

23/31

8.7.4

Mode select

In order to select the channel you want to evaluate, you must set a jumper on the board in

the relevant position for the SELECT pin (see Figure 31).

The channels selected depend on the position of the jumper:

●

With the jumper connected to the upper connectors, channel I at the output is selected.

●

With the jumper connected horizontally, channel Q at the output is selected.

●

With the jumper connected to the lower connectors, both channels are selected,

relative to the clock edge.

Figure 31.

Mode selection

SELECT

DVCC

DGND

CLK

I channel

Q channel

I/Q channels

SELECT