The SN74HC86 has standard CMOS inputs, so input signal edge rates cannot be slow. Slow input edge

rates can cause oscillations and damaging shoot-through current. The recommended rates are defined in the

Recommended Operating Conditions.

Refer to Section 8.3 for additional information regarding the inputs for this device.

9.2.1.3 Output Considerations

The positive supply voltage is used to produce the output HIGH voltage. Drawing current from the output will

decrease the output voltage as specified by the VOH specification in the Electrical Characteristics - 74. Similarly,

the ground voltage is used to produce the output LOW voltage. Sinking current into the output will increase the

output voltage as specified by the VOL specification in the Electrical Characteristics - 74.

Unused outputs can be left floating. Do not connect outputs directly to VCC or ground.

Refer to Section 8.3 for additional information regarding the outputs for this device.

9.2.2 Detailed Design Procedure

1. Add a decoupling capacitor from VCC to GND. The capacitor needs to be placed physically close to the

device and electrically close to both the VCC and GND pins. An example layout is shown in Section 11.

2. Ensure the capacitive load at the output is ≤ 70 pF. This is not a hard limit, however it will ensure optimal

performance. This can be accomplished by providing short, appropriately sized traces from the SN74HC86

to the receiving device.

3. Ensure the resistive load at the output is larger than (VCC / IO(max)) Ω. This will ensure that the maximum

output current from the Absolute Maximum Ratings is not violated. Most CMOS inputs have a resistive load

measured in megaohms; much larger than the minimum calculated above.

4. Thermal issues are rarely a concern for logic gates, however the power consumption and thermal increase

can be calculated using the steps provided in the application report, CMOS Power Consumption and Cpd

Calculation

9.2.3 Application Curves

Reference

Clock

Input Clock

Out

Figure 9-2. Typical application timing diagram

SN74HC86, SN54HC86

SCLS100F – DECEMBER 1982 – REVISED APRIL 2021

www.ti.com

12

Submit Document Feedback

Copyright © 2021 Texas Instruments Incorporated

Product Folder Links: SN74HC86 SN54HC86