Cabling the Switch

Figure 6: Front Panel Ports

1 Ethernet management port

2 USB port

3 Console serial port

Connect the front panel ports as follows:

•

Console (Serial) Port: Connect to a PC with the RJ-45 to DB-9 serial adapter cable. The switch

uses the following default settings:

•

9600 baud

•

No flow control

•

1 stop bit

•

No parity bits

•

8 data bits

•

Ethernet Management Port: Connect to 10/100/1000 management network with RJ-45 Ethernet

cable.

•

USB Port: The USB port may be used for software or configuration updates.

Important:

Excessive bending can damage interface cables, especially optical cables.

Flexion excessive peut endommager les câbles d'interface, notamment des câbles optiques.

13