ST10F273 datasheet(45/179 Pages) STMICROELECTRONICS

部品番号	ST10F273

部品情報	16-bit MCU with 512 Kbyte Flash memory and 36 Kbyte RAM

PDF	179 Pages

Scroll/Zoom	100%

メーカー	STMICROELECTRONICS [STMicroelectronics]

ホームページ	http://www.st.com

Logo

45 / 179 page

ST10F273

Bootstrap loader

45/179

6.3

Alternate and selective boot mode (ABM & SBM)

6.3.1

Activation of the ABM and SBM

Alternate boot is activated with the combination ‘01’ on Port0L[5..4] at the rising edge of

RSTIN.

6.3.2

User mode signature integrity check

The behavior of the Selective Boot mode is based on the computing of a signature between

the content of 2 memory locations and a comparison with a reference signature. This

requires that users who use Selective Boot have reserved and programmed the Flash

memory locations.

6.3.3

Selective boot mode

When the user signature is not correct, instead of executing the Standard Bootstrap Loader

(triggered by P0L.4 low at reset), additional check is made.

Depending on the value at the User key location, following behavior will occur:

●

A jump is performed to the Standard Bootstrap Loader

●

Only UART is enabled for bootstraping

●

Only CAN1 is enabled for bootstraping

●

The device enters an infinite loop.

ST10F273 データシート(PDF) 45 Page - STMicroelectronics