Special Recommendations

VIPer53EDIP - E / VIPer53ESP - E

18/31

DocRev1

11

Special Recommendations

10nF capacitor (minimum value: 8nF) should always be connected to the COMP pin to

ensure correct stability of the internal current source Figure 12 on page 22.

In order to improve the ruggedness of the device versus eventual drain overvoltages, a

resistance of 1k

Ω should be inserted in series with the TOVL pin, as shown on Figure 12 on

page 22

Note:

This resistance does not impact the overload delay, as its value is negligible prior to the

internal pull-up resistance (about 125k