ST10F273E datasheet(81/179 Pages) STMICROELECTRONICS

部品番号	ST10F273E

部品情報	16-bit MCU with 512 Kbyte Flash memory and 36 Kbyte RAM

PDF	179 Pages

Scroll/Zoom	100%

メーカー	STMICROELECTRONICS [STMicroelectronics]

ホームページ	http://www.st.com

Logo

81 / 179 page

ST10F273E

System reset

81/179

sufficient: anyway, a maximum of 100nF on V18 pin should

not generate problems of over-current (higher value is

allowed if current is limited by the external hardware).

External current limitation is anyway recommended also to

avoid risks of damage in case of temporary short between

V18 and ground: the internal 1.8V drivers are sized to drive

currents of several tens of Ampere, so the current shall be

limited by the external hardware. The limit of current is

imposed by power dissipation considerations (Refer to

Electrical Characteristics Section).

In next Figures

15 and 16 Asynchronous Power-on timing diagrams are reported,

respectively with boot from internal or external memory, highlighting the reset phase

extension introduced by the embedded FLASH module when selected.

Note:

Never power the device without keeping RSTIN pin grounded: the device could enter in

unpredictable states, risking also permanent damages.

ST10F273E データシート(PDF) 81 Page - STMicroelectronics