F2913 Datasheet

© 2017–2023 Renesas Electronics Corporation

15

February 8, 2023

Evaluation Kit (EVKit) Operation

External Supply Setup

1. Set up a VDD power supply in the range of +2.7V to +5.5V with the power supply output disabled.

2. Connect the disabled VDDsupply connection to J6 pins 1, 3, 13, or 15 and GND to J6 pins 2, 4, 6, 8, 10, 12, 14, or 16.

Logic Control Setup

1. With the logic control lines disabled, set the HIGH and LOW logic levels to satisfy the levels stated in the electrical specifications table.

2. Connect the disabled logic control to J6 VCTRL1 (pins 5 or 7) and VCTRL2 (pins 9 or 11).

3. See Table 7 for the logic truth table. Note that C1 in the table corresponds to VCTRL1 on the EVKIT and C2 corresponds to VCTRL2.

Turn On Procedure

1. Set up the supplies and EVKIT as noted in the External Supply Setup and Logic Control Setup sections above.

2. Enable the VDD supply.

3. Enable the logic control signals.

4. Set the logic settings to achieve the desired Table 7 configuration. Note that external control logic should not be applied without VDD

being present.

Turn Off Procedure

1. Set the logic control pins to 0V.

2. Disable the VDD supply.