02H, not 00H, because the first two registers in LP3943 are read-only registers. It is possible to write to the first

two registers independently, and the LP3943 device will acknowledge, but the data is ignored.

If auto increment is disabled, and the I2C master does not change register address, it continues to write data into

the same register.

Figure 6-7. Programming With Auto Increment Disabled (in WRITE Mode)

Figure 6-8. Programming With Auto Increment Enabled (in WRITE Mode)

LP3943

SNVS256E – NOVEMBER 2003 – REVISED OCTOBER 2024

www.ti.com

12

Submit Document Feedback

Copyright © 2025 Texas Instruments Incorporated

Product Folder Links: LP3943