Easy analysis of WLAN 802.11ac transmitter with a WLAN preset that provides spectral

emission mask, constellation diagram, and decoded burst information.

Bluetooth transmitter testing

With option SV27, you can perform Bluetooth SIG standard-based

transmitter RF measurements in the time, frequency, and modulation

domains. Option SV27 supports Basic Rate and Low Energy Transmitter

measurements defined by Bluetooth SIG Test Specification RF.TS.4.2 for

Basic Rate and RF-PHY.TS.4.2 for Bluetooth Low Energy. Option SV27

also automatically detects Enhanced Data Rate packets, demodulates

them and provides symbol information.

Pass/Fail results are provided with customizable limits and the Bluetooth

presets make the different test set-ups push-button.

Below is a summary of the measurements that are automated with option

SV27 (unless noted):

Bluetooth Low Energy Transmitter Measurements

Output power at NOC TRM-LE/CA/01/C and at EOC TRM-LE/CA/

02/C

In-band emission at NOC TRM-LE/CA/03/C and at EOC TRM-LE/

CA/04/C

Modulation characteristics TRM-LE/CA/05/C

Carrier frequency offset and drift at NOC TRM-LE/CA/06/C and at

EOC TRM-LE/CA/07/C

Basic Rate Transmitter Measurements

Output power TRM/CA/01/C

Power Density TRM/CA/02/C (no preset)

Power Control TRM/CA/03/C (no preset)

Tx output Spectrum – Frequency Range TRM/CA/04/C (no preset)

Tx output spectrum - 20dB Bandwidth TRM/CA/05/C

Tx output spectrum - Adjacent Channel Power TRM/CA/06/C

Modulation characteristics TRM/CA/07/C

Initial carrier frequency tolerance TRM/CA/08/C

Carrier frequency-drift TRM/CA/09/C

The following additional information is also available with SV27: symbol

table with color coded field information, constellation, eye diagram,

frequency deviation vs time with highlighted packet and octet, frequency

offset and drift detailed table as well as packet header field decoding.

Markers can be used to cross-correlate the time, vector and frequency

information.

Datasheet

www.tek.com 5