the work for you, you can just interface with it as if it were an Adafruit_GFX

compatible display. If you prefer not to use the chip, our libraries will

automatically use the microcontroller/microcomputer internal RAM.

For ultra-low power usages, the onboard 3.3V regulator has the Enable pin

brought out so you can shut down the power to the SRAM and display. By

default the RESE resistor is set to 0.5 ohms, which is the most common value,

but by cutting/soldering the bottom solder jumper you can set the resistor to 3

ohms.

Comes assembled and tested, with some header. You'll need a soldering iron to

attach the header for breadboarding or installing into your project. Does not

come with an EInk display!For use with just about any EInk display that has a

24-pin FPC connector. See these schematics to verify that your display matches

before purchasing.

 

TECHNICAL DETAILS

Product Dimensions: 34.7mm x 21.5mm x 3.5mm / 1.4" x 0.8" x 0.1"

Product Weight: 3.4g / 0.1oz