ST10F271Z1T3 datasheet(44/185 Pages) STMICROELECTRONICS

部品番号	ST10F271Z1T3

部品情報	16-bit MCU with 128 Kbyte Flash memory and 12 Kbyte RAM

PDF	185 Pages

Scroll/Zoom	100%

メーカー	STMICROELECTRONICS [STMicroelectronics]

ホームページ	http://www.st.com

Logo

44 / 185 page

Bootstrap loader

ST10F271Z1

44/185

6.3

Alternate and selective boot mode (ABM and SBM)

6.3.1

Activation of the ABM and SBM

Alternate boot is activated with the combination ‘01’ on Port0L[5..4] at the rising edge of

RSTIN.

6.3.2

User mode signature integrity check

The behavior of the selective boot mode is based on the computing of a signature between

the content of 2 memory locations and a comparison with a reference signature. This

requires that users who use selective boot have reserved and programmed the Flash

memory locations.

6.3.3

Selective boot mode

When the user signature is not correct, instead of executing the standard bootstrap loader

(triggered by P0L.4 low at reset), additional check is made.

Depending on the value at the user key location, following behavior will occur:

●

A jump is performed to the standard bootstrap loader

●

Only UART is enabled for bootstraping

●

Only CAN1 is enabled for bootstraping

●

The device enters an infinite loop.

ST10F271Z1T3 データシート(PDF) 44 Page - STMicroelectronics