19 Inches Rack Accessories

Strips, Nuts and Panel Fixing Kits

Page <1>

14/04/12 V1.1

www.element14.com

www.farnell.com

www.newark.com

Feature:

• A range of caged nuts suitable for fixing front panels on sub-rack systems

instrument cases, etc. Available in two thread sizes, each of which is suitable for

two ranges of material thickness. The steel nut is held captive in a spring steel

cage. Nuts and cages are zinc-plated

Specification Table

Dimensions : Millimetres

Caged Nuts

Cage Type

Panel Range

(Material Thickness)

Nut Size

H

R

C

Part Number

M5 Narrow

0.71 to 1.63 (22 to 16 s.w.g)

11.1SQ × 4.8TH 9.53

0.81

5.8

SCF008

M6 Narrow

SCF010

M5 Wide

1.83 to 2.64 (15 to 12 s.w.g)

SCF009

M6 Wide

SCF011

Important Notice : This data sheet and its contents (the "Information") belong to the members of the Premier Farnell group of companies (the "Group") or are licensed to it. No licence is granted for the use of

it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces

all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use

made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted.

Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising)

is excluded. This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. Multicomp is the registered trademark of the Group. © Premier Farnell plc 2012.