IO Expansion HAT for Pi Zero/Zero W

SKU:DFR0604

Introduction

This DFRobot IO Expansion HAT provides Digital, Analog, I2C, PWM, UART and SPI port

to meet all your needs. It is pretty small and perfectly suitable for Raspberry Pi

Zero/Zero W. The board leads out the I/O ports on Raspberry Pi including IIC, UART, SPI

and digital, among which the digital ports are led out via the GPIO16~GPIO25(BCM) of

Raspberry Pi, so these ports can be directly used. Besides, the PWM and Analog ports

are led out through the on-board MCU STM32 that can communicate with Raspberry Pi

via IIC. So combing with our related libraries, users are able to conveniently use

Raspberry Pi to control PWM output or read ADC input.

Specification

•

Power Supply: 5V

•

External Power Supply (Servo): 6-12V

•

Device Address: 0x10

•

Dimension: 65x30mm/2.56x1.18”