L9945TR datasheet(2/144 Pages) STMICROELECTRONICS

2 / 144 page

Applications

•

Automotive 12 and 24 V (passenger and commercial vehicles) applications

•

Low-side, high-side, Peak and hold and H-Bridge load control

•

Designed for driving relays, motors, and all the resistive and inductive loads

Description

The L9945 is an 8-channel MOSFET pre-driver configurable for low-side, high-side, peak and hold and H-Bridge

load control. It is designed to comply with the requirements of 12 V (passenger vehicle) and 24 V (commercial

vehicle) battery systems.

All outputs can be PWM controlled. Six outputs are capable of driving safety relevant loads. One output can be

dedicated to the actuation of safety relevant loads requiring a dedicated enable pin (EN6).

The device offers the possibility of controlling two independent H-Bridges.

The device can also drive up to two loads requiring "peak & hold" control strategy.

The driver outputs are protected against short circuit condition.

The device protects the external MOS in case of an overcurrent event.

Each output provides full diagnostic information such as short to battery, short to ground and open-load. Each

output status can be constantly monitored through dedicated SPI registers.

The voltage slew rate of the external transistors 1-8 is controlled during turn ON and turn OFF in order to improve

EMI behavior.

A double, redundant, external disable source is available through DIS and NDIS pins in order to improve safety.

The device is configurable via SPI through a 32-bit protocol.

L9945

DS12275 - Rev 10

page 2/144

L9945TR データシート(PDF) 2 Page - STMicroelectronics