2

Setting up the B-MOTOR-PMSMA1

This section is, for instance, applicable to the B-G473E-ZEST1S ZeST Discovery kit, which works with a variety of

power boards, such as the STEVAL-LVLP01.

2.1

Setting up the motor

The stripped and tinned leads of R57BLB50L2 must be inserted and fixed in the cable entry of the power board as

shown in Figure 1.

Figure 1. Motor connected to the cable entry of the power board

Cable entry of power board

Stripped and tinned leads of motor

Blue

W

Yellow

V

Orange

U

There is a Hall sensor connector on the R57BLB50L2 motor. Hall sensor signals can be connected to the Hall

sensor connector of the power board through external wires.

Note:

Be careful to connect the corresponding wire to the correct pin on the power board.

The pin definition of the Hall sensor connector on the motor is shown in Figure 2.

B-MOTOR-PMSMA1

Setting up the B-MOTOR-PMSMA1

DB5053 - Rev 1

page 3/6