M25P05 datasheet(10/32 Pages) STMICROELECTRONICS

10 / 32 page

M25P05

10/32

Figure 8. Write Enable (WREN) Sequence

Write Enable (WREN)

The Write Enable (WREN) instruction (Figure 8)

sets the Write Enable Latch (WEL) bit.

The Write Enable Latch (WEL) bit must be set pri-

or to every Page Program (PP), Sector Erase

(SE), Bulk Erase (BE) and Write Status Register

(WRSR) instruction.

The Write Enable (WREN) instruction is entered

by driving Chip Select (S) Low, sending the in-

struction code, and then driving Chip Select (S)

High.

Figure 9. Write Disable (WRDI) Sequence

Write Disable (WRDI)

The Write Disable (WRDI) instruction (Figure 9)

resets the Write Enable Latch (WEL) bit.

The Write Disable (WRDI) instruction is entered by

driving Chip Select (S) Low, sending the instruc-

tion code, and then driving Chip Select (S) High.

The Write Enable Latch (WEL) bit is reset under

the following conditions:

– Power-up

– Write Disable (WRDI) instruction completion

– Write Status Register (WRSR) instruction com-

pletion

– Page Program (PP) instruction completion

– Sector Erase (SE) instruction completion

– Bulk Erase (BE) instruction completion

AI02281D

34567

High Impedance

Instruction

AI03750C

34567

High Impedance

Instruction

M25P05 データシート(PDF) 10 Page - STMicroelectronics

M25P05 データシート(HTML) 10 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32

データシートダウンロード